If any of the following error codes are displayed on the LED (alternately flashing between the letter “E” and then a “Number” followed by another “Number”), please press the or button to dismiss the error, and then repeat steps 1 and 2. Make sure that the (blue) Wi-Fi lamp on the printer is also lit. When wireless connection is complete, the LED lights up for about 3 seconds, then changes to '1' as shown in the illustration below. The (blue) Wi-Fi lamp on the printer will ﬂash while searching for, or connecting to the access point.ģ. Make sure that the LED ﬂashes as shown in the illustration above, then press the button on your access point within 2 minutes.įor exact details regarding pressing the WPS button, please refer to the access point manual. Make sure that the LED ﬂashes as shown in the illustration below.Ģ. Press and hold the button (A) on the printer for approximately 5 seconds.Ģ. If the power is on, the LED (Light Emitting Diode) is lit as shown in the illustration below.ġ. Most WPS enabled access points use this protocol. Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol.If the WPS push button is not available please use the instructions in the Standard Connection Method section. Please check with your device’s user guide for details. The access point must have a physical WPS push button available.Use Canon consumables to ensure optimum performance and superb quality with every print.īefore we start, there are some conditions that must be met in order to use the WPS push button method: Take complete creative control of your images with PIXMA and imagePROGRAF PRO professional photo printers. Get productive with a range of small office printers that are your ideal companions.Įnjoy high quality performance, low cost prints and ultimate convenience with the PIXMA G series of refillable ink tank printers.

Functional and stylish home photo printers and all-in-ones delivering quality results.

Canon mx459 printer driver download